Doubled-sided PEI Powder-coated spring steel sheet with magnet 3M base makes for the best all around build surface. Textured or smooth finish depending on the side you use. Easy to remove plate from printer then simply bend a little to pop prints off.
Powder coating directly on metal makes it very hard to damage this build plate. If a heated nozzle crashed into it, the metal can dissipate the heat. Powder coating also gives the surface a distinct textured look that will be visible on your prints. The textured surface hides most of the mechanical damage caused by tools.
PLA ABS PETG TPU PVA etc.
Fits CR10, CR10S Pro etc.
Wipe the print surface before and after a print with isopropyl alcohol to maintain a clean surface for maximum bed adhesion strength. As with any build surface, make sure you are not printing too close to the bed to avoid possibly infusing the filament into the build surface. If printing PETG, TPU, TPE, and RYNO, make sure the bed is heated BEFORE attempting to remove the print from the bed.
1* Steel sheet
1* Magnet base