Skip to content

colorFabb LW-ASA Black Filament | 1.75MM, 0.65KG Spool

$69.95

colorFabb Lightweight ASA (LW-ASA) material is capable of increasing its volume nearly 2.5 times. The filament density is close to 1.07 g/cm3 but when foamed at its maximum capacity users will achieve part density close to 0.43 g/cm3.

After printing the LW-ASA Black will turn slightly lighter shade of black.  When foamed the surface finish will also turn matte, which gives a very professional looking result. Due to higher temperature resistance of LW-ASA, you don’t need to worry about heat absorption.

Key Features

  • Light weight
  • UV resistant
  • High temperature resistant

Please note that colour variations may occur. Colour will turn lighter when material is at maximum foamed state as opposed to non-foamed state which shows a deeper and richer colour. 

SPECIFICATIONS:

Recommended Nozzle Temp: 240-260°C
Recommended Bed Temp: 90-100°C
Recommended Print Speed: 30-50 mm/s

Active Cooling Fan: To reduce warping we would advice to use the least amount of cooling possible. Also for best mechanical performance try printing with the least amount of cooling needed, for optimal layer adhesion.

 

Material: colorFabb LW-ASA
Diameter Tolerance: ± 0.1 mm
Vicat Softening Temperature: 96°C

Out of stock

colorFabb Lightweight ASA (LW-ASA) material is capable of increasing its volume nearly 2.5 times. The filament density is close to 1.07 g/cm3 but when foamed at its maximum capacity users will achieve part density close to 0.43 g/cm3.After printing the LW-ASA Black will turn slightly lighter shade of black.  When foamed the surface finish will also turn matte, which gives a very professional looking result. Due to higher temperature resistance of LW-ASA, you don’t need to worry about heat absorption.

LW-ASA is more susceptible to warping compared to LW-PLA type filament. Especially models with a large footprint can shrink and warp during printing, but compared to ABS in most cases less severe.

Tip! Apart from using a large brim and heated build plate of 90-100°C (or higher if your machine is capable), you can also try the following:

Print a tall skirt around your model to reduce cold air flow around the printed model or print inside an enclosure for better control of the environment temperature.

Key Features

  • Light weight
  • UV resistant
  • High temperature resistant

Please note that colour variations may occur with colorFabb LW-ASA. Colour will turn lighter when material is at maximum foamed state as opposed to non-foamed state which shows a deeper and richer colour. 

COLORFABB SPECIAL FILAMENTS

Innovation never stops at colorFabb. Our ever expanding range of special filaments have been industry leading for years. Some of them are for aesthetic purposes, others are pure functionality or for specific niche applications. Materials like woodFill, bronzeFill, XT-CF20, LW-PLA, varioShore TPU and DPA-100 support filament were developed in-house and have been successes ever since. By listening to our customers’ needs and forging strategic partnerships with material OEMs we are able to innovate continuously and bring FDM/FFF 3D printing to the next level.

For more info, check out the colorFabb website!

PACKAGING

Within minutes of production, colorFabb 3d printing filament is sealed airtight with a double barrier foil. Filament spools are then packed in a cardboard box for further protection. colorFabb 3d printing filament is fresh and ready for 3d printing right out of the box.

Weight 1 kg
Dimensions 20.5 × 20.5 × 6.5 cm

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.